Residential · Heating & Controls
Electric Heating & Thermostats in Greater Vancouver
From a single baseboard swap to in-floor heat, heat-pump circuits and smart thermostats throughout the home — we wire and control heating so it's warm where you want it and quiet on your power bill.
- Licensed, insured & bonded
- Certified BC Master Electricians
- 24/7 emergency response
Other residential services
Heating done right
Heat that runs efficiently — and controls that actually behave
Most older Vancouver homes mix and match: a couple of baseboards in the addition, a wall heater in the bathroom, a dated mechanical thermostat that overshoots by three degrees. We fix that.
We install and repair baseboard heaters, electric in-floor heating systems, electric fireplaces, patio heaters, and the dedicated circuits for heat pumps and air conditioning. We also wire and configure smart thermostats — line-voltage, low-voltage and Wi-Fi — so each room actually holds its setpoint.
Every install is led by a Certified BC Master Electrician, fully insured and bonded, with permits pulled and inspections coordinated when required.
What's included
A complete heating & controls service, under one licence
One contractor, one quote, one accountable team — from the breaker to the thermostat on the wall.
- Baseboard heater installation, repair and replacement
- Electric in-floor heating systems and controls
- Forced-air and electric fireplace circuits
- Dedicated circuits for heat pumps and A/C
- Smart and programmable thermostats (line and low voltage)
- Humidistats and bathroom fan timers
- Patio and outdoor electric heaters
- Load calculations and breaker sizing
Quick service request
Book your heating estimate
Free, no-obligation. A Certified BC Master Electrician will follow up within one business day.
Why Electric Hero
Homeowners choose us for heating because we wire it to behave.
Certified BC Master Electricians
Every install is led by a certified Master Electrician — not an apprentice winging the load on your panel.
Thermostats that match the heater
Line-voltage, low-voltage, Wi-Fi — we pair the right control with the right heater so it actually holds setpoint.
Efficient by design
Right-sized circuits, proper grounding and zoned controls — heat where you want it, not the whole house.
Built for BC homes
Heritage plaster, mid-century slab, modern high-performance builds — we've wired heat in all of them.
FAQ
Electric heating, answered
Can you replace just the thermostat?+
Often yes — if your existing wiring and heater are sound, we can swap the thermostat in under an hour. We'll confirm whether your heater needs a line-voltage or low-voltage control before we recommend a model.
Do baseboards need their own circuits?+
It depends on wattage. We do a quick load calculation and confirm whether your existing circuit can carry the additional heater or if a new dedicated circuit is required by code.
Can you wire for a heat pump?+
Yes. We install the dedicated circuit, disconnect and any required panel work for ductless mini-splits and central heat pumps, and coordinate with your HVAC contractor on timing.
Do you install smart thermostats?+
Yes — Nest, ecobee, Mysa, Sinopé and others. We confirm compatibility with your heaters, run a C-wire where needed, and configure the schedule with you before we leave.
Free estimate · same-week scheduling
Heat your home properly — book today.
Speak with a Certified BC Master Electrician about your heating and thermostats. No pressure, no surprises — just a clear quote.